AVV-711 Quick Book
70
W ORKFLOW OF THE CONFIGURATION
Enter number of planes(bores), press
and edit value in textbox (the value should be in range 3-300)
If measured planes evenly positioned(equal distances used) press
to make checkbox
checked
Press
and enter distance then. If distances not equal use
to select plane and press
then
enter distance from this to next plane. Repeat for each planes except last.
If only three measure points for each plane will be used (not recommend) it is good practice to
define bore diameter for that plane(this can improve accuracy). To enter diameter press
and enter
value for selected plane.
Next step setup parameters (if any). Press
parameters screen appears.
To change of use manual input press
, to change of use manual angle(need for vertical chains)
press
. To change display units between metrical and inches press
.
For using averaging press
enter averaging samples number and press
Press
to save and exit.
13.2 TAKING MEASURE MENTS
Form main screen press
. Measure screen appears
Cautions in this screen
Shortcuts in this screen
Perform coarse adjustment of the laser
beam when start new task
To clear current plane measurements(all
stored measurements will be lost)
Tasks in this screen
To manually enter detector value(V)
·
Taking
measurements
·
Manually enter data(if manual data
chosen in parameters)
·
Manually enter angle(if manual angle
To manually enter angle(degrees)
To toggle display units
