AVV-711 Quick Book
81
COARSE ADJUSTMENT OF THE LASER BEAM
Position the laser transmitter (S-unit by default) as close to object beginning (or to the first overlapped
point on splice if splices used). Place the receiver (M-unit by default) at the closest position to the
transmitter. Adjust the position of the transmitter so the laser beam hits approximately centre of the target
of receiver. Look to beam position indicator on the display. After that, move receiver as far from the
transmitter as possible, but still on the object (or on the current splice if splices used).
Adjust the angle of the laser beam using adjustment screws on transmitter, so the laser beam hits
approximately centre of the target of receiver. Move receiver to the first measurement point. Check that is
appropriate point no. / splice no.(if any) selected on the display.
If the laser beam is far from centre of the target, repeat adjustment procedure.
Coarse adjustment should be performed once for object or for each splice if splices used.
Do not touch transmitter (or adjust receiver) during measurement!
TAKE, REVIEW AND REPLACE MEASURE
To take measure press
. Stored values will be showed as result.
For review stored measures use up and down arrow keys. For replace selected measure press
,
confirmation dialog appears press “Yes”.
Detector Y-axis value
Stored
measure
/result
(empty here)
Stored measures count
(empty here) value
changed to 1 when
measure stored
Detector X-axis value
Point no.
Splice no. (if used)
overlapped point no.
Visible when current
point is overlapped point
of the splice
