AVV-711 Quick Book
99
REFERENCE PLANE MODES
There are three reference plane modes, to switch between them use
key
No reference plane
mode: result is the unchanged detector value;
Laser plane
mode: when no reference points defined result is the unchanged detector value;
when three reference points are defined result is the difference between calculated three point reference
plane and the detector value.
Best fit plane
mode: when best fit mode selected result is the difference between calculated best fit
reference plane and the detector value
DEFINE REFERENCE POINTS, DEFINE ZE RO POINT
You can define/clear reference points only in laser plane mode.
To define or clear reference point using arrow keys for select desired position, then press
(do not hold
it more than 1 sec). To define zero point (usually first point of measurements) press
and hold it more
than 2 sec until only one reference
point showed (see figure beneath).
no reference plane
laser plane
Reference
point
Best fit plane
Reference points listed
here
Reference points listed
here
