AVV-711 Quick Book
111
18. SQUARENESS PROGRAM
Squareness program is used for perpendicularity measurement of two surfaces
Rotating laser transmitter RL-20 can deflect laser beam precisely by 90 degree by the means of a
pentaprism. These two perpendicular laser beams are used as a reference. Four readings should be
taken – two on the one of the surfaces, then laser beam direction should be switched and another two
readings taken on the other surface. Place laser transmitter at the common corner of surfaces. Place
detector (M-Unit by default) at the first position. Perform rough laser beam alignment if necessary.
18.1 MAIN SCREEN OF THE PROGRAM
Cautions in this screen
Shortcuts in this screen
Required dimensions should be properly
entered(but you can edit it later if need,
measure data will not affected)
To start new task or repeat measurement
(all data will be lost)
Tasks in this screen
To enter number of points(positions) to
measure
·
Enter
dimensions
·
Start
measurement
·
View results(available when all
measurements taken)
·
Save
file
To enter distances
To save to file, see
1-2 dimension
3-4 dimension
