AVV-711 Quick Book
112
BASIC WORKFLOW
Mark two positions (near and far from transmitter) on the first surface and do the same on second surface
this is a points of measurements
Enter dimensions between position press
to enter 1-2 dimension, confirm input by
then enter 3-4
dimension, confirm input by
Place laser transmitter at the common corner of the surfaces, place receiver(M-Unit by default) at the
first(far from) position.
Press
to go to measure
18.2 TAKING MEASURE MENTS
Press
to take measure.
Use
keys to change selected point.
Press
to return from measure
After taking measurements for 1 move detector to 2 position and take measure. Then rotate laser
90 degrees toward second surface. Taking measurements for 3 and 4 positions.
The AVV-RL20 laser must not be moved after measurement
has commenced. Switch laser beam direction carefully!
The order of taking data is not important.
Laser beam
position indicator
Means data not
ready(wait)
Means beam
out of target
Means connection to
transducer not established
Blinking yellow
shows selected point
Selected point no.
Stored value, not
present if no value
stored
