AVV-711 Quick Book
19
5.2 TO CHANGE PROGRAM PARAMETERS
To change program parameters press
Cautions in this screen
Shortcuts in this screen
Use biaxial live only where weak shafts
coupling present
To select/reset use manual input
Tasks in this screen
To select/reset use manual angle
·
Select to use manual input or transducers
data
·
Select to use manual angle or
inclinometers embedded in transducers
·
Select default display resolution
to 2 or 3 decimals
·
Select default measure unit metric mm or
uk inches(mils)
·
Select to enable biaxial live aligning(use
both Y and X coordinates) or use single Y
coordinates only(default)
To select/reset use 2 decimals resolution
(when reset it is 3 decimals)
To choose between measure unit metric mm
or uk inches(mils)
To select/reset biaxial live aligning mode
To save and exit
Filter(averaging) setup
use
to confirm
input
