AVV-711 Quick Book
20
5.3 TO COLLECT DATA
To collect data press
Cautions in this screen
Shortcuts in this screen
Before starting new alignment task you
must enter dimensions and setup
program parameters
DO NOT change the positions of
measuring units at the time of interruption
of the work
The laser beams turned on now
To start from scratch(clear all readings).
Confirm dialog appears
Tasks in this screen
To enter Ys value when manual input mode
selected
·
Collect readings from transducers(up to
36)
·
Choose between auto sweep and manual
modes
·
Enter manual Ys, Ym values
(if manual input is selected)
·
Enter manual angle
(if use manual angle is selected)
·
Choose measure units(mm/mils)
·
Navigate through collected readings
·
Delete/add/replace
readings
·
Start from scratch(clear all readings)
option
·
Set
offset
(extend Y values range) option
·
Save collected readings
To enter Ym value when manual input
mode selected
Enter manual angle when manual angle
mode selected
When edit value in edit box press twice
when cursor at first position to enter
negative sign(“-”)
To select measure units(mm / mils)
To setup offset
To save collected data to file, see
To load previously saved data from file, see
