AUTO PICLE-S
34
2 Speed cannot be controlled (The motor runs)
3 The machine will not move (The motor runs)
4 The machine runs incorrectly
Problem
Possible cause
Solution
Defective speed
control resistor
Remove the connector of SCR control and apply
the probes of a tester to resistor terminals 2 and 1,
or 2 and 3. If the pointer continuously moves from 0
to 50 k
q
when the handle is turned slowly, the
resistor is normal.
Replace the
defective resistor.
Defective controller
If the above item is normal, the controller is
defective.
Replace the
defective controller.
Problem
Possible cause
Solution
Malfunction
Remove the speed reducer box to check the clutch
operation.
Disassemble and
clean.
Idle rotation of
reduction gear.
The reduction gear is rotating idly when the motor
keeps running even if the direction changeover
switch is turned on or the drive wheel is stopped by
hand.
Replacement of
gears (set).
Problem
Possible cause
Solution
The speed is too
fast.
The supply voltage is abnormal.
Check the voltage.
Low speed is not
possible
Speed control resistor is defective.
Replace with a new
one.
Defective wiring.
Correct the wiring.
Defective motor.
Repair or replace
the motor with a
new one.
Defective controller
Replace with a new
one.
High speed is not
possible
When the supply voltage has dropped.
Check with a tester.
Knocking occurs.
Abrasion of gears.
Replace.
Auto Picle-S.book Page 34 Thursday, April 11, 2002 11:15 AM
Summary of Contents for AUTO PICLE-S
