IK-12 NEXT
- 32 -
Not used
Not used
Not used
Not used
Torch switch signal minimum time setting
Setting range: 0.4
～
1.5 s
At shipment from factory: 0.7 s
Sets the time to guarantee the ON/OFF state of the torch switch. Reducing
this value may mean that the welding power source is unable to receive a
signal, so care is required.
Speed, Position Display Unit, Inch Setting
0 : mm display
1 : Inch display
After setting this parameter, switch the power off and back on.
Speed Correction
Setting range: 50
～
200%
At shipment from factory : 100%
Sets the value for correcting the actual speed with respect to the speed
indicated at the digital display.
Actual speed = speed displayed × [This parameter value]%
Not used
Model Selection Setting
0: WH-MULTI NEXT
1: IK-12NEXT
After setting this parameter, switch the power off and back on.
When using the IK-12NEXT, be sure to set this parameter to 1.
Creeping mode
* This is the same as the CREEP setting made with the multi-function
selector switch.
Use the CREEP setting on the multi-function selector switch.
Travel mode (1)
* This is the same as the SPEED (1) setting made with the multi-function
selector switch.
Use the SPEED (1) setting on the multi-function selector switch.
Travel mode (2)
* This is the same as the SPEED (2) setting made with the multi-function
selector switch.
Use the SPEED (2) setting on the multi-function selector switch.
