PNC-12 EXTREME
24
Daily maintenance
1. Do not stand on, step on the rail and don’t put heavy object to lean against the track. Also don’t hit
the track. Each working shift shall use compressed air to remove dust on the guide rail surface and
use gauze to stain 20# engine oil to wipe the track surface. Keep the guide rail surface lubricant and
clean at any time.
2. It is required to use 20# engine oil to clean the transmission rack every day. It is not allowed to leave
slug powder on the rack.
3. Only operators should be allowed to change cutting nozzle. They shall not disassemble other parts.
The electrical connection box can only be opened when admitted person overhauls.
4. If problem occurs to this device, service person shall be requested to repair it immediately. When
problem is difficult to solve, it is required to report to related section and person to review and
determine a repair scheme. It is strictly forbidden to disassemble and check the machine without
authorization.
Safety guarantee
1. Since this type of work is a special type of work, the operators must have the license of this type of
work issued by the labor bureau.
2. Only authorized workers shall work. Unauthorized person shall not enter to machine area and shall
not push buttons without authorization. This is to avoid damaging the machine or missing data.
3. Strong vibration source shall be placed around the machine.
4. When move the machine, be careful to the equipment should not be fallen or hit. s. And please be
careful the machine shouldn’t be out of the rail. All equipment include rail shouldn’t be hit.
5. The power source line of the machine shall be used independently and AC voltage stabilizer shall be
installed.
6. Ventilation or replacement of gases and clearing of cutting nozzle must be executed according to
the procedure of dangerous gas safety operation.
7. To prevent viruses, operators shall not load external programs to the machine memory without
addition. Only special software recognized by our factory can be used.
7 WARRANTY INSTRUCTIONS
1. The warranty period is one year since the date of sales invoice.
2. If various problems are occurred and qualified inspector found those problem occurs due to poor
manufacturing, the manufacturer will be responsible for repairing the machine.
3. It is not included in the warranty scope that loses and damages are bear by improper transport,
improper keeping, operation failure, voltage that is out of stipulated range, etc.
4. Any losses and damages caused due to disassemble the machine by non-professional persons will
be out of warranty scope.
