PNC-12 EXTREME
4
3.2.4
Installation of Cross Bar..................................................................................14
3.2.5
Assembly of Motorized Up/Down Device, Distributor and Solenoid Valve Unit
15
3.2.6
Connection......................................................................................................15
3.2.7
Connection to Gas Supply ..............................................................................15
3.3
installation of Plasma Cutting to Standard Machine (with arc
voltage control) ..............................................................................16
3.3.1
Step 1: replace torch unit ................................................................................16
3.3.2
Step 2: install arc voltage control ....................................................................17
3.3.3
Step 3: Install 8P motorized Up/Down control cable and 3P motorized
Up/Down control cable:............................................................................................17
3.4
Addition of Plasma Cutting in Standard Machine (with arc
voltage regulated up) .....................................................................18
3.5
Addition of Oxy-Fuel Cutting Function in Plasma Model ............18
3.6
Gas Supply of Relevant Devices....................................................18
3.7
following options are available upon customer’s request ..........18
3.8
Control Panel ...................................................................................19
4
Brief Introduction to MACHINE Parts .................................21
4.1
Mechanical Movement Structure ...................................................21
4.2
Fluid System ....................................................................................21
5
Machine Maintenance and Preservation ............................21
5.1
Machine Cleaning............................................................................21
5.2
Machine Lubrication .......................................................................22
5.3
Machine Adjustment .......................................................................22
5.4
Cleaning of Cutting Nozzle.............................................................22
6
Operation of Cutting Torch ..................................................22
6.1
Shutdown of Cutting Torch ............................................................22
