PNC-12 EXTREME
7
Be sure to wear protector's gauntlets, goggles, helmet, and safety shoes during operation.
Avoid operating the machine with wet clothes or hands in order to prevent electric shock.
1.1.3
Operation and handling safety precautions
1. Read this instruction manual before operating the machine.
2. Mount and center the machine correctly and confirm correct motion before operation.
3. Prior to connecting the power plug with the socket, make sure the power switch in OFF position
(turn the switch clockwise or counterclockwise to the stop position).
4. Prior to operating the machine, check the safety of the surroundings to avoid accidents.
5. Never move the machine while the preheat flame is on.
6. When an operation is carried out at a higher position, be careful that the splashes and slugs may
hurt others at lower position.
7. Be sure that the clutch is in state of meshing before operation, any improper state may cause
accidents.
8. Be careful that the hands may be caught in erecting guide rail.
9. When cutting along the guide rail, be sure to fix the small guide roller properly.
10. Erect the preheat board properly to avoid affection to the guide rail.
11. To avoid that holder of torch from falling, use the bolt on the sliding holder to fix it.
12. Be sure to hold tight of handles in moving the equipment.
13. Prior to moving guide rail, be sure to move the equipment out of the guide rail.
1.1.4
Electrical system precautions
1. Be sure to check the input power voltage of the machine before operation. The input power voltage
should be in the range of +10% of the rated voltage. The machine should not be operated out of
this range.
2. Be sure to keep the layout of power cable reasonable, so that the cables will not be caught in the
equipment operation.
3. Be sure to ground the power cable or use a socket with earth wire.
Stop operation and turn off the power in the following cases, and ask a qualified electrician to repair
the machine.
a) Broken or abraded cables
b) When the machine has been in contact with water, or in case of liquid damage to the
machine.
c) Abnormal machine operation despite operating the machine according to the
instruction manual
d) Machine
breakdown
e)
Poor machine performance that requires repair
4. Periodically inspect the electrical system.
1.1.5
Maintenance and inspection precautions
1. Ask a qualified electrician to perform repair and inspection service.
2. Disconnect the power plug before inspecting and repairing the machine.
3. Maintain the machine periodically.
1.2 GAS CUTTING SAFETY PRECAUTIONS
Strictly observe the safety rules and precautions to ensure the safety of gas cutting operations. Operators
and supervisors MUST keep safety in mind.
