13
Pin location
Pool size
For pools where the shortest length is 3 meters or above
If the robot does not cover the entire pool with either
pin position 1 or 3, try below setting. If the situation
persists, deploy the robot from a different location.
For pools where the shortest length is 3 meters or below.
(Factory setting)
Pool Preparation
- If there are stones, roots or metal corrosion in contact with the underside of the liner,
discard them prior to using the robot. If necessary, seek assistance from a qualified
professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform
the necessary repairs or perform a liner replacement prior to using the robot.
- Remove any pool ladder, surface skimmer, and other floating objects from the pool
as they may obstruct the movement of the robot’s float and, consequently, the
movement of the robot also.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the
robot into the water.
IMPORTANT NOTE:
Turn off the filtration
system (as instructed in your filtration
manual) at least 15 minutes prior to deploying the robot.
Summary of Contents for Delta 200
Page 95: ...94 NOTE NOTA NOTITIE NOTIZEN ...
