9
the pool. Longer hose is provided for the connection of the heater to the pump/filter,
and short hose is provided for connection of additional heater as shown. If the length
of hoses provided does not fit your pools, you can use another soft hose with same
diameter.
Hose Connectors on the Main Base
Two hose connectors are preinstalled on the bottom of the main base. Center hose
connector is for hose connection to the pump/filter. Side hose connector is for hose
connection to the pool return or additional
KEOPS
TM
solar Heater.
Before connecting to the hose, turn the side hose connector anticlockwise as shown
until it stops. The openings of 2 hose connectors should point in opposite directions.
To detach the hose connectors from the main base, turn the connectors clockwise
until it stops and then pull it away.
To assemble the hose connector to the main base, reverse the steps to finish
the assembly.
Assembling Dome Cover to Main Base
NOTE: Start this assembly after finishing all hose connections.
There are 4 tabs on dome cover and 4 slots on the solar heater base. Push the tab
into the slot to secure the dome cover on the heater base.
Summary of Contents for K835CBX/RV
Page 47: ...46 NOTE NOTA NOTITIE...
