FCC Notice
NOTE:
Complies with Federal Communications Commission Rules & Regulations Part 15,
Subpart B for a Class A digital device.
WARNING
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer’s instruction, may cause
interference to radio and television reception. It has been type tested and found to comply
with the limits for a Class A computing device in accordance with the specification in subpart
B of part 15 of the FCC rules, which are designed to provide reasonable protection against
such interference in a commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
interference to radio and television reception, which can be determined by turning
equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
•
Reorient the receiving antenna.
•
Relocate the equipment with respect to the receiver.
•
Relocate the equipment away from the receiver.
•
Plug the equipment into a different electrical outlet so that the equipment
and receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions.
The user may find the following booklet prepared by the Federal Communications
Commission helpful:
“Interference Handbook, Bulletin CIB-2”
This booklet is available from the U.S. Government Printing Office, Superintendent of
Documents, Mailstop SSOP, Washington, D.C. 20402-9328, ISBN 0-16-045542-1.
WARNING: Power must be removed from this unit before removing circuit modules or
Ribbon Cables.
CAUTION: This unit contains circuit cards with integrated circuit devices that can be
damaged by static discharge. Take all necessary precautions to prevent
static discharge.
