TECHNICAL HANDBOOK
INDUSTRIAL ROLLER SHUTTER_(RSM)
KOLLIAS Ltd.
Page 31/46
D.Z. –Ver.1
st
– 08/12/17
Address:
3rd km. National Highway Katerini - Thessaloniki
Katerini
Postal address:
P.O. Box : 91
60100, Katerini
Tel.:
+30 23510 36036
Fax:
+30 23510 45630
Web: www.kolliasdoors.com
STEP 4 : Rotating the roller shutter’s bases
Before fitting the roller shutter onto the mountings, make sure that the motor and safety brake
are in the correct position. To achieve this, we lift the roller shutter using either a crane or a forklift at a
desired work height. Then adjust the crank to the motor’s socket and rotate it, rotate the motor’s
mounting (Figure 4). Corresponding rotation work is done for the base of the safety brake, which can be
accomplished easily by hand.
Figure 4
STEP 5 : Positioning the roller shutter on the bearing and checking the gap between the shaft and the
base
Raise the roller shutter to a height slightly higher than that of the mountings and carefully move
the crane or forklift so that the bases lie above the guides mounting (Figure 5). Place the bases on the
mounting and then smoothly move the product, so that they come into contact with the upper part of
the guides.
