TECHNICAL HANDBOOK
INDUSTRIAL ROLLER SHUTTER_(RSM)
KOLLIAS Ltd.
Page 39/46
D.Z. –Ver.1
st
– 08/12/17
Address:
3rd km. National Highway Katerini - Thessaloniki
Katerini
Postal address:
P.O. Box : 91
60100, Katerini
Tel.:
+30 23510 36036
Fax:
+30 23510 45630
Web: www.kolliasdoors.com
The use of the industrial roller shutter is exclusively to operate as a barrier for the space it is
installed. No other use of the product is allowed (e.g. lifting operation). Industrial roller shutters are
designed, developed and assembled to withstand all loads that may appear, during its proper operation.
Any form of a misuse of the product may contributed with an excess overload that has not been taken
into account in their static study, therefore the manufacturer takes no responsibility for the failure of the
product or caused accident.
HANDLING ON STATIONARY OPERATION
Operation mode of the industrial roller shutter is fully controlled and automated. The curtain is
set for ascent or descent with the operator's interaction on the corresponding button of the basic fixed
controller and stops immediately by stopping any activity on it. When the curtain reaches its upper or
lower motion, it stops automatically via the terminal switches, even if we continue to operate with the
button.
In case of circuit voltage drop, every function of the industrial roll is immediately interrupted.
After resetting the voltage to the desired levels, an effect is required on each roller control board as each
given command is automatically canceled.
REMOTE CONTROL
As mentioned above, the operation of the roller shutter with instant command by remote
control is possible both for upward and downward movement of the curtain.
In the case of automatic ascending and descending of the curtain, the device is necessarily
equipped with a photocell placed at a height of 50 - 80 mm from the ground and a pressure switch fitted
to the floor sealant, in order to avoid accidents during the unintentional influence on the controller, but
also in case of an obstacle within the opening, which the remote user does not is aware of or notice.
In case, where only the automatic ascent of the roller shutter is desired, the device is not
required to carry a photocell and a pressure switch, since the descent is affected by the operator at the
button of the fixed control operation.
