11
© 2020 Kolpin Outdoors Inc.
REV 00
SPORTSMAN REASSEMBLY (General):
26.
Using the winch kit instructions, route and connect the
electrical cables and components for the winch system.
27.
Make sure there are no exposed wires or terminals. Tightly
bind all loose wires and attach away from moving parts and
heat sources.
2021 SPORTSMAN 450/570 MODELS:
28.
Connect all red (positive) wires to the positive battery
terminal. Connect all black (negative) wires to the negative
battery terminal. Tighten to specification. (See illustration 1
-
24).
Note, put the winch wire through the opening in the
electrical boot that covers the main vehicle power wire.
29.
Put front bumper cover onto vehicle and identify area to be
trimmed on both sides of bumper cover. (See illustration
1
-
25).
30.
Cut along marked lines.
31.
Install front bumper cover with four fasteners. Tighten until
fully seated. (See illustration 1
-
26).
32.
Close front rack and attach two rubber latches.
33.
Install accessory front brush guard, if equipped.
34.
With key in ON position, test winch for proper operation.
WARNING
When
BOTH
battery cables are disconnected
ALWAYS
connect
AND
tighten red positive (+)
battery cable
FIRST
. Failure to comply will result in
high current electrical arc that may result in battery
explosion, if tool touches grounded frame. Death or
serious injury may occur.
!
!
Ill. 1
-
24
BATTERY BOLT TORQUE:
60 in
-
lbs. (6 N
-
m)
Ill. 1
-
25
Ill. 1
-
26
Ill. 1
-
27
