Instr 26-3200; 26-3210
Rev 01 2020-11
Page 8 of 17
4. Remove and keep four bolts from lower front
bumper cover.
5. Remove and discard two push pin rivets from
winch cover. Remove and discard winch cover.
NOTICE
Before installing winch kit, add or replace proper fluid
to your vehicle's front gear case as required in the
service manual. This process will be difficult to do
after winch is installed.
ACCESSORY INSTALLATION
WINCH INSTALLATION
2021 SPORTSMAN 450/570 MODELS
1. Make sure wire routing and connections are as
shown and make necessary adjustments.
2. Put red and black wires through the opening
where the winch will go. Move winch onto radiator
mount.
IMPORTANT
Check all wires are free to move, not pinched
between vehicle chassis and winch assembly.
3. Install two screws
y
on each side to attach winch.
Torque to specification.
NOTICE
On models with strut front suspension, use front set
of holes for mounting winch.
TORQUE
Winch Mounting Screws
y
:
17 ft-lbs (23 N·m)
