Instr 26-2000
Rev 01 2020-09
Page 8 of 12
6. Connect dash harness
r
to switch.
IMPORTANT
Wires must be connected in order shown.
• Top “Out” – Green wire
• Middle – Red wire
• Bottom “In” – Black wire
7. Drill a
1 in (25 mm)
hole in dash panel.
8. Install remote port into drilled hole and mark screw
holes on dash panel. Remove remote port.
9. Drill two holes
5/32 in (4 mm)
in dash panel.
10. Install two screws
y
and two washers
u
to attach
remote to dashboard. Tighten until fully seated.
11. Connect wire splitter
w
to switch harness, remote
harness, and vehicle accessory harness.
12. Put remote harness and switch harness down
through vehicle by winch.
13. Connect remote harness
t
to switch harness
r
.
Attach to frame with one cable tie
i
.
