69
FIG-19. Electric System
Troubleshooting
IGNITION COIL
Remove the spark plug cap from the spark plug.
Disconnect the ignition coil primary wire.
Measure the primary coil resistance.
STANDARD: 0.1-0.30
Ω
Measure the secondary coil resistance with the spark
plug cap in place.
STANDARD: 7.4-11 K
Ω
IGNITION TIMING
The ignition advance is 13
∘ ±
1
∘
/4000rpm
The capacitive discharge ignition (CDI) system is
factory pre-set and does not require adjustment.
ALTERNATOR EXCITER COIL
Remove the seat/ rear fender and front fender.
disconnect the exciter coil wire.
Measure the resistance between the yellow or white or
green wire and ground.
STANDARD : 467-700
Ω
Battery Electrolyte is poisonous. Drink large quantities
of water or milk and call a physician if swallowed.
INTERMITTENT ENGINE POWER
LOOSE BATTERY CONNECTION
LOOSE CHARGING SYSTEM
CONNECTION
STARTER MOTOR WILL NOT TURN
DEAD BATTERY
FAULTY IGNITION SWITCH
LOOSE OR DISCONNECTED WIRE
STARTER MOTOR AND ENGINE TURN,
BUT ENGINE DOES NOT START
FAULTY IGNITION SYSTEM
FAULTY ENGINE STOP SWITCH
ENGINE PROBLEMS
HEAD LIGHT DO NOT WORK
THE SWITCH DO NOT PUSH TO THE
“ON”
POSITION
THE LIGHT BULB IS BURN OUT, NEED
BE REPLACED
Summary of Contents for 180??
