Fig 1.2 Bottom
2. Main features
-
9 indipendent programs
-
Up to 99 screw for each program
-
Min and max fastening time (accuracy: 0.01sec)
-
User confirmation: active stop motor: push OK, to start a new cycle.
-
In case of error, push ESC to continue (active stop motor).
-
Password at the first starting and every time after the unit has been switched off
-
Sequence of 4 programs
-
Statistics: total number of correct screws done, wrong screws, cycles done, sequences done
-
Connectors on the back panel with output signal of OK, NOK and END CYCLE
-
Remote control of the system (optional)
-
RS232 port
3. Main Display
The ACE Screw Counter offers 2 different modes of operation:
-
Single program/Cycle,
-
Sequence.
SINGLE PROGRAM: to perform a cycle for each program. The display will show all the
parameters needed to run the program.
SEQUENCE: to perform up to 4 programs in sequence. On the display the selected programs need
more information: screws done, screws to be done, total programs of the sequence and the program
you are in.
