3. Menu
To enter the menu, push ESC for 1 sec.
At the first starting, you must digit a password: through UP/DOWN keys, digit the number and
push OK to save it. Default password: 0000.
Menu:
1) Program: X
2) Screw : XX
3) Tmin : X.XX
4) Tmax : X.XX
5) Reset : YES/NO
6) Password
7) Sequence YES/NO
8) Sequence: XXXX
9) Statistic
To enter, select through UP/DOWN and push OK:
1) Program: to select the desired program. Once set, Pieces and Time will automatically be
loaded. The selected program will be used in “Single Program” mode.
Select the program through the UP/DOWN keys and push OK to save it or ESC to exit
without saving.
2) Screws: to select the number of pieces for each program.
Select the program through UP/DOWN keys and push OK to save it or ESC to exit without
saving.
3) Tmin: to set the minimum fastening time. Reaching the torque under the min time will result
in error. The min time must be lower than the max time. Select the program through
UP/DOWN keys and push OK to save it or ESC to exit without saving.
consente di inserire il tempo minimo di avvitatura. Se l'avvitatore arriverà in coppia in un
4) Tmax: to set the maximum fastening time. Reaching the torque over the max time will result
in error. In this case the screwdriver will stop and the operator will be advised on the display
and with 3 beep sounds. The max time must be higher than the min time.
Select the program through UP/DOWN keys and push OK to save it or ESC to exit without
saving.
5) RESET: if active, at the end of each program, push OK to start a new program. If not active,
the new program will start automatically. The end of the cycle will result on the display and
in a beep sound. Select the program through UP/DOWN keys and push OK to save it or
ESC to exit without saving.
6) Password: you can select a new password instead of the default 0000. Push OK and digit the
numbers through UP/DOWN, then push OK to save each value.
7) Sequence YES/NO: if YES, you can activate the sequence or a functioning sequence of the
pres-set programs (see § 8).
-
Push OK to enter
