Page 13
5. Press OK. You will see:
- - - - - - - - S T E P - - 1 - - - - -
S t a r t
t e s t
Complete a screwing cycle on the mini k5 and take note of torque value, in this case 1.40Nm.
- - - - - - - - S T E P - - 1 - - - - -
P r e s s
O K
t o
c o n f i r m
o r
E S C
t o
r e p e a t
6. Press ESC to abort the calibration process.
Press OK, then the display will show:
- - - - - - - - S T E P - - 1 - - - - -
E n t e r
t o r q u e
v a l u e :
0 0 . 0 1 Nm
Set the torque value to 1.40 Nm by
selecting each digit individually pressing
and
and press OK to
confirmit, then press OK again to save. You will see:
- - - - - - - - S T E P - - 2 - - - - -
E n t e r
t h e
p e r c e n t a g e :
2 2 %
7. Set the percentage of the second torque to 30% by pressing
and press OK.
8. Repeat the procedures described on points 4 and 5.
9. When calibration ends, “Setting end”
will be displayed. You will hear two beep sounds, too.
Now you are ready to work and see the correct torque on the display.
- - - - - - - - S T E P - - 2 - - - - -
E n t e r
t h e
p e r c e n t a g e
2 0 %
Summary of Contents for EDU 2AE/TOP/NT
Page 17: ...Page 17 I O CONNECTIONS...
