EXPLANATION OF COMPONENTS
OPERATION
3-16
ENGINE PRE-HEATING PILOT LAMP
Lamp (5) indicates that engine is being pre-heated by the elec-
trical heater during cold weather.
The engine controller detects the coolant temperature and
automatically actuates pre-heating in low temperatures when
starting the engine.
DISPLAY PANEL A (speed range display, engine speed)
Meter (6) displays the transmission speed range being used on
the machine and engine speed.
q
When the transmission is in 1st FORWARD, the display
shows F1, and when it is in 1st REVERSE, the display
shows R1.
q
The peripheral bar graph indicates the engine speed.
When the red range lights up during running, shift the gear
to a lower speed to run the engine at a speed within the
green range.
DISPLAY PANEL B (Multi-information)
This monitor (7) displays information related to the condition of
the machine on the top and bottom lines of the display portion.
The content of the display can be switched by operating the
Information switch and Buzzer cancel switch.
(1) Operating mode (normal operation screen)
Use this mode when operating the machine.
REMARK
When the starting switch is turned from the OFF to the ON
position, the multi-information display changes to the operating
mode.
The bottom right of the monitor displays the total hours of operation of the machine. Use this service meter func-
tion display to set the intervals for periodic maintenance.
When the engine is running, the service meter advances, even if the machine is not being operated.
When the engine is running, the operation display of the hourglass mark on the side of the meter lights up to show
that the meter is advancing.
The meter advances by 1 for one hour of engine operation, regardless of the engine speed.
The failure code is also displayed on the top line if there is a failure on the machine. If it is displayed, follow the
action given in “OTHER TROUBLE (3-146)“.
Engine speed
Speed range
Red
Summary of Contents for 76243
