98
INSTRUMENTS AND CONTROLS
The display (17) indicates which wheels must be aligned through
the relevant symbols:
- Front wheels misaligned (see Fig. d).
- Rear wheels misaligned (see Fig. e).
Once the wheels are aligned, the relevant symbols go out and
the acoustic alarm stops.
IMPORTANT
☞
•
In case of replacement of the rear axle, the monitor, the
potentiometer, the sensor or any other component of the
steering system, it is necessary to carry out the alignment
of the rear wheels, by proceeding as follows:
- turn the steering wheel clockwise and anticlockwise,
until the rear wheels are aligned;
- before checking the alignment of the wheels, stop the
machine;
- press the push buttons (1-2-3) shown in Fig. (c) at the
same time;
- keeping the three buttons pressed, turn the key to posi-
tion «I» to activate the electric signal;
- after a few seconds the writing “KOMATSU” will appear
on the monitor (17), followed by the symbol that indi-
cates the alignment of the rear wheels (
);
- press the push button (1) shown in Fig. (c);
- the correct alignment of the rear wheels is signalled by
the coming on of the green warning light (A) and by the
display of the symbols “KM/h or MP/h” on the monitor
(17), as shown in Fig. (b).
CHECK
FRONT AXLE
SERVICE
17
RWA34780
d
CHECK
REAR AXLE
SERVICE
17
RWA28480
e
CHECK
SERVICE
RWA27670
2
1
3
c
CHECK
SERVICE
A
RWA28450
17
CHECK
SERVICE
A
17
b
000KM/h
000MP/h
Summary of Contents for 97SF11205
