165
USING THE MACHINE AS AN EXCAVATOR
3.13.3 SLIDING THE BACKHOE UNIT SIDEWARDS
IMPORTANT
☞
•
Before moving the backhoe unit, make sure that the sliding guides are clean and lubricated with
grease.
1 - Lower the stabilizers (1) to avoid overloading the rear wheels and to prevent the machine from oscillating.
2 - Swing the boom (2) against the machine.
3 - Manoeuvre the bucket (3) and the arm (4) until the bucket teeth are perpendicular to the ground when the arm
and the boom form an angle of approx. 90°; plant the bucket teeth onto the ground.
4 - Release the backhoe unit (see “3.3.5 MACHINE CONTROLS” pos. 10).
5 - Make the unit slide by manoeuvring the arm.
CAUTION
•
Carry out this manoeuvre by operating the arm opening/folding lever smoothly, in such a way as to
maintain the sliding support in vertical position and therefore facilitate its sliding.
6 - Lock the unit.
IMPORTANT
☞
•
If the machine is equipped with backhoe servo controls, disable the servo control locking function by
means of the control locking switch positioned on the side dashboard.?See “3.3.5.2 MACHINE CON-
TROLS (Version with servo controls)” pos. 26.
RWA00710
1
1
2
3
4
Summary of Contents for 97SF11205
