REMOVAL AND INSTALLATION
WB97S-5
30-216
FRONT AXLE
14
-Once the pinion-ring gear backlash has been
established, measure the total preloading (T) of the
bearings (pinion-crown bevel gear system), using a
dynamometer whose cord is wound on the pinion
splined end. The measured value should be within the
following range:
T= (P+3.2)–(P+4.7) daN
where
P
is the effectively measured pinion preloading
(For details, see "9.2 Assembly" at point 13).
a
Warning:
All preloadings must be measured
without seal ring.
RKZC6920
15
-Once the pinion-ring gear backlash has been
established, instead proceding with a dynamometer,
measure the total rolling torque (TT) of the bearings
(pinion-crown bevel gear system) with a torquemeter.
a
Warning:
All preloadings must be measured
without seal ring.
RKZC6750
16 -The total rolling torque TT must be within the following
range:
TT= (TP+0.55)–(TP+0.82) Nm
where
TP
is the pinion bearings preloading.
(For details see "9.2 Assembly" at point 14).
RKZ12150
T
T
17 -If the measurement is not within the requested range,
check well the assembly of each component and
operate on the adjuster ring nuts (5) and (9) of the
differential support:
A - if the total preloading
is less
than the given range,
screw in both adjuster ring nuts (5) and (9) by the
same measure, keeping the pinion-ring gear
backlash value unchanged;
B - if the total preloading
is greater
than the given
range, unscrew both adjuster ring nuts (5) and (9) by
the same measure, keeping the pinion-ring gear
backlash value unchanged.
A
A
B
B
RKZ12400
Summary of Contents for WB97S-5
