1.
Select the “Design face Date Hold Time in Initialize” (4) on
the “Semi-auto Adjustment” screen, and press the switch
“F6”.
F3: Moves to the next item (1 line below). When it is on the
last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When it is
on the first line, it moves to the last line.
F5: Returns the display to “MC Setting” screen.
F6: Changes the setting of selected item.
“Design face Date Hold Time in Initialize” setting screen is
displayed.
2.
Set how long it takes for the “Semi-auto limited digging
mode” is canceled from the time when GNSS receiver
starts initialization.
It is set at “60 secinds” when machine is shipped from
plant.
F3: Moves to the next item (1 line below). When it is on the
last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When it is
on the first line, it moves to the last line.
F5: Cancels the change and returns the display to “MC
Setting” screen.
F6: Validates the change and returns the display to “MC Setting” screen.
METHOD FOR ADJUSTING SURFACE TOTAL SWING HOLD ANGLE AT INITIALI-
ZATION
Set the swing angle to be held from the time when GNSS receiver starts initialization to the time when the
“Semi-auto limited digging mode” is canceled.
1.
Select the “Cumulative Swing Angle Set in Initialize” (5) on
the “Semi-auto Adjustment” screen, and press the switch
“F6”.
F3: Moves to the next item (1 line below). When it is on the
last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When it is
on the first line, it moves to the last line.
F5: Returns the display to “MC Setting” screen.
F6: Changes the setting of selected item.
“Cumulative Swing Angle Set in Initialize” setting screen is
displayed.
2.
Set the swing angle to be held until the “Semi-auto limited
digging mode” is canceled when GNSS receiver starts initi-
alization.
It is set at “250 degree” when machine is shipped from
plant.
F3: Moves to the next item (1 line below). When it is on the
last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When it is
on the first line, it moves to the last line.
F5: Cancels the change and returns the display to “MC
Setting” screen.
SETTING
MACHINE MONITOR
7-193
Summary of Contents for A31001
