6.
Check that the work equipment is on the design data.
(Check that warning message of “Out of design area...” is
not displayed on the control box.)
7.
Check that all control levers are at NEUTRAL position.
8.
Tap the Mode Selection button (3) on the control box, and
select either “Fine Digging” working mode (A) or “Rough
Digging” working mode (B).
Semi-auto mode is not available if the travel mode (C) is
selected.
9.
Press the auto/manual switch (4) on the top of the control
box.
Be sure to check that the tilting angle is stabilized, and
then press the auto/manual switch (4) when the tilt bucket
is installed.
The symbol (5) indicating semi-auto mode is displayed on
the screen of control box, and voice signal sounds when
the semi-auto mode is selected.
The symbol (5) indicating semi-auto mode is displayed for
a certain time, and then it is automatically cleared.
$-'
5
AJD03154
EXECUTIONS
SEMI-AUTO MODE
8-7
Summary of Contents for A31001
