10. Adjust the control box to the position for you to see it well.
11. Turn the handle (2) of mount to screw it in, and fix the con-
trol box so that it does not move.
12. Check that the clearance with the control box is enough for
the work equipment lever when it is moved.
(Keep 40 mm {1.6 in} or more for the clearance (a).)
METHOD FOR REMOVING LOWER CAB FRONT WINDOW
1.
Lower the work equipment to the level ground, and set the
lock lever (1) securely to LOCK position (L).
2.
Stop the engine.
3.
Open the front window (upper side), then hold the grip (2),
pull it up, and remove the lower side window.
If sand or dust is collected at the bottom of the front win-
dow (lower side), it will be difficult to remove the window. In
addition, when stowing, the sand and dust stuck to the
glass will be carried inside the cab. To prevent this, clean
the area (A) before removing.
4.
Store the lower side window at the right rear of the opera-
tor's cab after it has been removed.
5.
Set the lever (3) to the lock position (B) to hold it securely
in position.
6.
Set the lever (3) to the release position (C), hold the glass
with both hands, and pull it up when removing the lower
side window.
EXPLANATION OF COMPONENTS
OPERATION
3-32
Summary of Contents for A31001
