NOTICE
• Check that the fuel control dial (2) is at Low idle (MIN)
position before starting the engine. The engine will ac-
celerate suddenly and cause damage to the engine
parts if the fuel control dial is at High idle (MAX) posi-
tion.
• Wait for the internal battery state LED of the control
box to light up in green or flashes alternately in green
and blue when it is lit in orange or red, and then start
the engine.
• The battery voltage may suddenly drop depending on
the temperature and the battery condition when start-
ing the engine. The control box may not start normally
at that time if the internal battery is not charged.
• Do not keep the starting switch key (3) at the START
position continuously for more than 20 seconds.
If the engine does not start, wait for at least 2 minutes,
then start again from the beginning.
• After the engine starts, wait for the engine oil pressure
caution lamp to go out. Do not touch the control levers
or control pedal while the engine oil pressure caution
lamp is lit.
This machine is equipped with an engine automatic preheating device that functions to start the engine preheat-
ing automatically.
The preheating monitor lights up when the starting switch key (3) is turned to ON position in order to inform the
operator that preheating has been started automatically when the ambient temperature is low.
Start the engine according to the following procedure.
1.
Check that lock lever (1) is at LOCK position (L).
If lock lever (1) is in FREE position (F), the engine does
not start.
2.
Turn fuel control dial (2) to Low idle (MIN) position.
MACHINE OPERATIONS AND CONTROLS
OPERATION
3-48
Summary of Contents for A31001
