3.
Raise the work equipment (blade) to the upper limit.
Perform the procedure 4 to 6 within 15 seconds.
Since the accumulator pressure decreases gradually after the engine stops, you can release only just
after the engine stops.
4.
With the work equipment at the upper limit, turn the start-
ing switch to OFF position (A), and stop the engine.
5.
Turn the starting switch to ON position (B).
6.
Set the work equipment lock lever to FREE position (F),
and move the blade control lever in LOWER direction full
stroke.
MAINTENANCE PROCEDURE
MAINTENANCE
4-72
Summary of Contents for D155AX-8E0
