End screen when any message has been received
If there is any message from your Komatsu distributor, it is displayed on the end screen DD for 5 seconds, and
then the screen goes out.
In this case, turn the starting switch to ON position to re-check the message, and if it is the message requesting
response, send back your reply.
End screen when there is any “Operational Advice”
If there is any “Operational Advice”, “Operational Advice” is displayed on the end screen EE for 5 seconds, and
then the screen goes out.
BASIC OPERATION OF MACHINE MONITOR WHEN STARTING SWITCH IS ON
WHILE OPERATOR ID INPUT IS SET
• If inputting the ID number for operator identification function (with SKIP) is set, the starting screen AA
switches to the ID number input screen LL (with SKIP) when the starting switch is turned to ON position.
• If inputting the ID number for operator identification function (without SKIP) is set, the starting screen AA
switches to the ID number input screen MM (without SKIP) when the starting switch is turned to ON posi-
tion.
• On the ID number input screen LL (with SKIP) or MM
(without SKIP), input the already registered ID number,
and press ENTER switch (1). The screen changes to the
check before starting screen BB. If you input an incorrect
ID number, press RETURN switch (2), and clear an input
character at a time.
On the ID number input screen LL (with SKIP), press the
menu switch (3), and the screen changes to the check be-
fore starting screen BB without inputting ID number.
EXPLANATION OF COMPONENTS
OPERATION
3-14
Summary of Contents for HD325-8
