METHOD FOR OPENING OPERATOR CAB DOOR
1.
Insert the starting switch key into the key slot (1).
2.
Turn the starting switch key to “OPEN” position (A), and
then remove the starting switch key.
Position (A)
OPEN
Position (B)
LOCK
3.
Hold the cab door handle (2) to open the cab door.
When getting on or off the machine, hold the inside handrail.
METHOD FOR LOCKING OPERATOR CAB DOOR
1.
Close the cab door.
2.
Insert the starting switch key into the key slot (1).
3.
Turn the starting switch key to “LOCK” position (B), and
then remove the starting switch key.
Position (A)
OPEN
Position (B)
LOCK
HANDLE TIRE
PRECAUTIONS WHEN HANDLING TIRES
k
k
WARNING
To ensure safety, the defective tires given below must be replaced with new tires.
• Tires where the bead wire has been cut, broken, or greatly deformed
• Excessively worn tires where more than 1/4 of the circumference of the carcass ply (excluding the
breaker) is exposed
• Tires where damage to the carcass exceeds 1/3 of the tire width
• Tires where ply separation has occurred
• Tires where radial cracks extend to the carcass
• Deteriorated, deformed or abnormally damaged tires, which do not seem usable.
MACHINE OPERATIONS AND CONTROLS
OPERATION
3-234
Summary of Contents for HD325-8
