SYSTEM ERRORS
The system automatically monitors for system abnormalities, in the event of an error the monitor display screen
(7) will display ERR and an audible intermittent buzzer will sound. In the event of a system error, stop work im-
mediately, move the machine to a safe place and contact your Komatsu distributor for support.
TRACK SHOES SELECTION
Select the appropriate track shoe to match the operating conditions.
Track shoe selection
Check the category from the uses in the table below, then select the shoes from the table further below.
• Category of use B and C are the wide shoe, so there are restrictions on the use. Check the precautions for
use, examine the conditions of use thoroughly, and use the optimum shoes for the situation.
• When selecting the shoe width, choose the narrowest shoes possible to bring the machine within the range
where there is no problem regarding the machine flotation and ground contact pressure. If the wider shoes
than necessary are used, the load on the shoe will increase. It may cause problems such as bending of the
shoe, cracking of the link, damage of the pin, and looseness of the shoe bolts.
Classification by use
Classifica-
tion
Use
Precautions when using
A
Rocky
ground, riv-
erbeds
Normal soil
•
On rough ground with large obstacles such as boulders or fallen trees, travel at
Lo speed.
B
Normal soil
Soft ground
•
These shoes cannot be used on rough ground where there are large obstacles
such as boulders or fallen trees.
•
Travel at Hi or Mi speed only on flat ground, and if it is impossible to avoid trav-
elling over obstacles, shift down and travel at half speed in Lo.
C
Extremely
soft ground
(swampy
ground)
•
Use the shoes only in places where the machine sinks and it is impossible to
use A or B shoes.
•
These shoes cannot be used on rough ground where there are large obstacles
such as boulders or fallen trees.
•
Travel at Hi or Mi speed only on flat ground, and if it is impossible to avoid trav-
elling over obstacles, shift down and travel at half speed in Lo.
D
Paved road
•
Take note of low grade ability due to flat shoes and exercise due care.
E
Paved road
•
Be sure to follow instructions set forth in the 'Handling of Road Liner' section for
the protection of the rubber pad shoes.
PC360LC-11
PC360NLC-11
Specification
Classification
Specification
Classification
Option
600 mm Triple grousers
A
600 mm Triple grousers
A
Standard
700 mm Triple grousers
B
700 mm Triple grousers
B
Option
800 mm Triple grousers
C
800 mm Triple grousers
C
Option
850 mm Triple grousers
C
N/A
N/A
BUCKET TEETH SELECTION
Depending on the working conditions, there is a danger that an adapter and tooth may be lost. Select either one
from the vertical pin type of tooth or horizontal pin type of tooth that is suitable for the purpose.
While the standard teeth of both vertical and horizontal pin types may be used widely, the following kinds of
teeth are recommended depending on the working conditions.
ATTACHMENTS AND OPTIONS
ATTACHMENTS AND OPTIONS
6-62
Summary of Contents for PC360LC-11
