E mode recommendation guidance
If light-load work is continued for more than 10 minutes in P
mode, E mode recommendation message is displayed. When
working on light load, set the working mode to E mode to re-
duce the unnecessary fuel consumption.
E mode recommendation message goes out after more than 10
seconds or if the switch F5 is pressed.
Travel partial mode recommendation guidance
If the machine keeps traveling for more than 2 minutes with the
travel mode Hi and the fuel control dial at High idle (MAX) posi-
tion, the travel partial mode recommendation message is dis-
played. When traveling for a long time, the fuel consumption
can be reduced by lowering the fuel control dial.
The travel partial mode recommendation message goes out af-
ter more than 10 seconds or if the switch F5 is pressed.
Low fuel level guidance
If the operable time estimated from the current fuel level and
the latest average fuel consumption is shorter than 8 hours, the
low fuel level message is displayed roughly.
The low fuel level message goes out after more than 10 sec-
onds or if the switch F5 is pressed.
Guidance for engine stop operation during the aftertreatment devices regenera-
tion
Immediately after starting the aftertreatment devices regeneration, the information about the engine stop opera-
tion during the aftertreatment devices regeneration is displayed as a rough guide.
When stopping the engine during regeneration of the aftertreat-
ment devices, stop the regeneration first, then stop the engine
after running it at low idle for approximately 5 minutes.
The information about engine stop operation during the after-
treatment devices regeneration goes out after more than 10
seconds or if the switch F5 is pressed.
OPERATION
EXPLANATION OF COMPONENTS
3-35
Summary of Contents for PC700LC-11
