Follow the procedure below for setting the stop valve to
FREE position (F) or LOCK position (L).
1) Remove the bolt (1) and washer (2).
2) Rotate valve to furthest position clockwise or anti-
clockwise.
3) After setting, refit the bolt (1) and washer (2).
12. After installing the attachment, check the oil level in hy-
draulic tank.
For details, see "METHOD FOR CHECKING OIL LEVEL
IN HYDRAULIC TANK, ADDING OIL".
LONG-TERM STORAGE
NOTICE
If there is no breaker or general attachment installed, operating the pedal may cause overheating and
other problems.
If the equipment is not to be used for a long time, do as follows.
• Set the stop valve in LOCK condition.
• Install the plugs to the piping end of the stop valve.
• Set the lock pin in LOCK position.
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT
ATTACHMENTS AND OPTIONS
6-12
Summary of Contents for PC700LC-11
