REMARK
• The progress of the manual stationary regeneration performed when soot is accumulated can be
checked by the number of lighting lamps of the soot accumulation level (4).
The manual stationary regeneration starts at the soot accumulation level “4” or higher and finishes
when all the level lamps go out.
• The time required for the manual stationary regeneration depends on the soot deposition level or the
ambient temperature when it is started.
• If the lock lever or the fuel control dial is operated during the manual stationary regeneration, the re-
generation is stopped automatically.
Return the lock lever to LOCK position (L) and return the fuel control dial to Low idle (MIN) position,
then repeat the procedure from step 6.
• If the machine needs to be moved during the manual stationary regeneration, stop the regeneration
temporarily and move the machine by referring to the aftertreatment devices regeneration disable and
cancel procedures described below.
When restarting the manual stationary regeneration, secure the safety of the machine and around it,
then cancel the regeneration disable.
8.
When the manual stationary regeneration is completed, the engine speed gradually decreases to low
speed, and the screen automatically returns to the standard screen.
PROCEDURE FOR AFTERTREATMENT DEVICES REGENERATION DISABLE
SETTING
If there is combustible material around the machine and the active regeneration that increases the exhaust tem-
perature must not be performed, the automatic active aftertreatment devices regeneration can be disabled.
The regeneration can be disabled while aftertreatment devices are in regeneration.
NOTICE
Even if the regeneration is disabled, KDPF soot accumula-
tion caution lamp (2) lights up if soot is accumulated and
the manual stationary regeneration is required. If KDPF
soot accumulation caution lamp lights up, move the ma-
chine to a safe place and perform manual stationary regen-
eration.
If the operation is continued without performing the man-
ual stationary regeneration, it may cause the failure of
KDPF or the engine.
While the regeneration is not being performed: Setting for the regeneration dis-
able
1.
When the aftertreatment devices regeneration pilot lamp is
not displayed on the standard screen
On the standard screen, press function switch “F4” to dis-
play the user menu.
OPERATION
EXPLANATION OF COMPONENTS
3-93
WENAM00241
Summary of Contents for PC80MR-5E0
