1.
Open the engine side cover on the right side of the ma-
chine.
2.
Place a container under the filter cartridge to catch the
fuel.
3.
Turn filter cartridge (1) counterclockwise by using the filter
wrench, and remove it.
4.
Clean the filter head. Thinly apply oil to the packing of the new filter cartridge and install the cartridge to the
filter head.
NOTICE
• Do not fill the new filter cartridge with fuel.
• Remove cap (A) at center and install the filter car-
tridge.
5.
When installing the cartridge, tighten it until the packing
surface contacts the sealing surface of the filter head, then
tighten it 1/2 to 3/4 turn.
REMARK
If the filter cartridge is fastened too much, the packing will
be damaged and this leads to leakage of fuel. If the filter
cartridge is too loose, fuel will also leak from the packing.
Therefore, be sure to observe the tightening angle.
When tightening with a filter wrench, be extremely careful
not to dent or damage the filter.
6.
Fill the fuel tank until full (to FULL mark on the fuel gauge) with fuel.
7.
Turn the starting switch to OFF position (A) and stop the
engine.
MAINTENANCE PROCEDURE
MAINTENANCE
4-52
Summary of Contents for WA480-8
