Komfovent C3.1, User'S Installation And Operation Manual

UAB KOMFOVENT we reserve the right to make changes without prior notice

17

C3.1-16-01

It is possible to restore emergency overheating protection with button 

“RESET”, only if before heater overheating cause has been clarified and 

eliminated.

If the unit is shut down and a failure text message is shown on the control 

panel, the fault must be eliminated! 

After failure has been eliminated and power supply connected the error messages should be deleted. How 

ever if the failure has not been eliminated, unit either starts operating and after some time it stops again, or it 

does not operate and failure message is indicated.

3. SAFETY REQUIREMENTS

•  To avoid accidents and/or unit damage, only a trained technician must 

carry out the connection.

•  The appropriate Personal Protective Equipment (PPE) attire is worn 

relative to the operation being carried out.

•  Electrical equipment is rated, connected and earthed in accordance 

with CE regulations.

Before performing any jobs inside the unit make sure that the unit is 

stopped and disconnected from the electrical power supply.

•  Earth must be installed according EN61557, BS 7671.

•  The unit should be installed according to Installation and Maintenance 

Manual.

• 

Before starting the unit, check correct position of air filters.

•  Service maintenance should be carried out only in conformity with the 

instructions specified herein below.