EN
UAB KOMFOVENT we reserve the right to make changes without prior notice
RHP-C5.1_21-01
10
3. INSTALLATION
3.1. Maintenance space requirements
It is recommended to install the air handling unit in a separate room or in the attic on a hard smooth
surface insulated with a rubber mat. The place for the unit must be selected with allowance for minimum
access to the unit for maintenance or service and must comply with safety requirements. Opening for
inspection can not be smaller than dimensions of the unit and unit itself must be mounted in a way, that
if needed (for example in case of complicated repair) it can be easily dismounted. The minimum free
space in front of the control panel should be not less than 700 mm. The free space over the top of the
unit should be at least 500 mm (3.1 a, b Picture).
Rubber mat must be used when unit is going to be mounted on the wall.
Minimum Maintenance Space
for Horizontal Units
m
in
. 5
00 m
m
min. 700 mm
min. 400 mm
3.1 a Picture
Minimum Maintenance Space
for Vertical Units
m
in
. 4
00 m
m
m
in
. 7
00 m
m
3.1 b Picture
