Komodo Hobby
www.komodohobby.com
4
Step 1
Step 2
Step 3
Step 4
1: Cut a 3ft-magnet wire “S1”
2: Remain 7-8cm long magnet wire for connection
use afterward.
3: At tooth No.1, start to wind 7times from the hub to
the outer edge of hammerhead. Then wind 6times
back to the hub.
1: Cut a 3ft-magnet wire “S2”
2: Remain 7-8cm long magnet wire for connection
use afterward.
3: At tooth No. 2, start to wind 7times from the hub
to the outer edge of hammerhead. Then wind
6times back to the hub.
1: Cut a 16ft magnet wire “S3”
2: Remain 7-8cm long magnet wire for connection
use afterward.
3: At tooth No. 3, start to wind 7times from the hub
to the outer edge of hammerhead. Then wind
6times back to the hub.
1: Put the magnet wire “S1” to tooth No.4
2: At tooth No. 4, wind 7times from the hub to the
outer edge of hammerhead. Then wind 6times
back to the hub.
