Komodo Hobby
www.komodohobby.com
6
Phase 3
3. Remove the coating of magnet wires
Step (9): Remain 7-8cm long magnet wire for
connection use afterward.
Use magnet wire “S3” to start to wind
11times in clockwise direction at tooth
No.3. Wind from the hub to the outer edge
of hammerhead then back to the hub.
Step (10): Jump to tooth No. 6 and start to winds
11times in clockwise direction as step (9).
Step (11): Jump to tooth No. 9 and start to wind
11times in clockwise direction as step (10).
Step (12): Cut the magnet wire “S3”. This ending of
wire will be called “E3” in the following
steps. Note: Remain 7-8cm long magnet
wire for connection use.
When you finish the winding steps above, you have 6
endings of magnet wire attached to coils. Use a shape
model knife to scrape off the coating of these six magnet
wires.
Then, it is necessary to check any short between
magnet wire and stator metal, and need to check any
short between magnet wires, S1, S2 and S3. If you find
any short between them, please be patience to rewind
them again.
Note: your Electronic Speed Controller, Receiver and
Battery can be destroyed by part defect of windings
.