GENERAL INSTRUCTIONS
To ensure the kegerator is properly used please review and follow the safety and installation
notices below.
Safety:
Installation:
3
• Plug into a grounded 3-prong outlet.
• Do not use extension cords or adapters to connect the unit to an electrical power source.
• The fuse for the outlet where the unit will be plugged in should be at least 15 amps.
• The kegerator should not be installed in an area where it will be exposed to any water.
• Never allow children to climb inside the appliance. If no longer in use - remove the door or secure shut so children
cannot become trapped inside the unit.
• California Proposition 65 Warning: This product contains a chemical or chemicals known to the State of
California to cause cancer and birth defects or other reproductive harm.
• After moving the unit it is best to allow it to stand upright for 24 hours prior to plugging in to the power source.
• Do not pinch/kink the power supply cord.
• For proper heat dissipation make sure there is sufficient and proper air ventilation around the kegerator. The
kegerator dispenser vents from the grill below the door. The right side is “cold air in” and the left side is “warm air
out”. Make sure the kegerator can vent adequately from the front vent. This will allow the heat to escape quickly
enough to ensure consistent cooling. Not installing properly may cause the kegerator to fail prematurely and void
the warranty.
• Place out of direct sunlight and other sources of heat. The best room temperature range is from 65°F– 80°F.
• Once the unit is in place, level it by adjusting the feet on the bottom.
• Clean the interior with a soft damp washcloth.
• And finally, after plugging in the kegerator allow it to cool down for 4 hours prior to putting a keg inside.
