■
66
│
GB
QC 360 A1
Setting the speed level
The quadrocopter has two speed settings you can use depending on your flight
experience level.
♦
Set the speed selector switch to the position "–" for a slower speed. This speed
setting is recommended for pilots who have little or no flight experience.
♦
Set the speed selector switch to the position "+" for a higher speed. This speed
is recommended for pilots who already have experience with flying quadrocopter
models.
Barrel roll
Once you have acquired a bit of experience with the quadrocopter, you can
attempt a barrel roll.
♦
Fly the quadrocopter up to a height of about 2–3 metres and keep it hovering.
♦
Press the control lever downwards. The remote control emits a continuous
beep to signal that the quadrocopter is in barrel roll mode.
♦
Move the control lever in one direction (forwards/backwards/right/left).
The quadrocopter will then do a barrel role in the corresponding direction.
Calibration
If the quadrocopter shows a tendency to move off in one direction (drift), you will
need to calibrate it.
♦
Place the quadrocopter on a dry and level horizontal surface.
♦
Pull the throttle lever to the lower left corner and the control lever to the lower
right corner at the same time. The quadrocopter’s control lamps will flash for
3 seconds. As soon as the control lamps light up permanently, calibration is
complete and the quadrocopter is ready to fly again.
Summary of Contents for 272322
