■
16
│
GB
│
IE
KM 250 C1
Food processing attachments
1) Select the desired attachment:
–
the slicer attachment
3
–
or the grater attachment
-
.
2) If a different disk is still installed: Ideally, turn
the disc adapter
upside down. Press the
long metal tab of the disc inwards with your
thumb so that this side of the disc is released
from the disc adapter
. You can now remove
the disc.
3) Insert the new disc with the short metal tab first
into the disc adapter
:
4) Then carefully push the side with the long metal
tab into the disc adapter
. The best way to
do this is to press with both thumbs on the
outer edges of the attachment until it clicks
completely into place in the disc adapter
.
5) Place the disc adapter
with the attachment
fitted onto the drive shaft
. The flattened side
of the drive shaft
must correctly fit into the
take up of the disc adapter
. Otherwise the
disc adapter
cannot be properly attached.
6) Place the lid
onto the bowl
so that the
arrow ▼ on the lid
coincides with the
arrow
and the opened lock symbol
on the bowl
.
7) Turn the lid
until the arrow ▼ on the lid
points to the arrow
and the closed lock
symbol on the bowl
.
8) Place the pusher
into the feed tube
.
9) Insert the plug into a mains power socket.
Operation
Using the cutting blades
The cutting blades
can be used to chop foods
such as onions or meat.
NOTE
►
Do not attempt to mix liquids with the cutting
blades
. These will overflow or spray out.
1) Fit the cutting blades
as described in the
chapter “Assembling the appliance”.
2) Cut the ingredients into pieces of
approximately 2 – 3 cm.
3) Pour the ingredients in. Do not exceed the
quantities specified in the following table.
INGREDIENT
MAX. AMOUNT
SPEED
Bread
max. 80 g
ON
Cheese
max. 150 g
ON
Meat
max. 300 g
ON
Herbs
max. 30 g
ON
Garlic
80 – 200 g
PULSE
Onions
max. 300 g
PULSE
Ice cubes
max. 140 g
PULSE
Summary of Contents for 339545 1910
Page 3: ......
