CR 5 A2
GB
│
MT
│
75
■
Cleaning
CAUTION
Damage to the device!
►
To avoid irreparable damage, ensure that no moisture penetrates the device
during cleaning .
►
Do not use any abrasive or solvent-based cleaners as these can damage the
device housing or the device itself .
■
Clean the surfaces of the device with a soft, dry cloth . Use a normal commercial
detergent and water to remove stubborn residue . Ensure that no water gets into
the device .
Troubleshooting
This section contains important information on fault identification and rectification .
Observe the instructions in order to avoid risks and damage .
WArNING
►
Repairs to electrical devices may only be carried out by specialists trained by
the manufacturer . Improper repairs can cause considerable risks to users and
damage to the device .
Fault causes and rectification
The following table will help to identify and rectify minor faults:
Fault
Possible cause rectification
The camera is not
working with the
built-in battery .
The battery is flat . Charge the built-in battery from a
switched-on computer connected to
the
connection on the device,
or the on-board electrical system of
your vehicle .
The camera does not
work in the vehicle .
The vehicle's
battery is flat .
Charge the vehicle's battery .
The fuse in the
car adapter
is defective .
Replace the fuse (see section
Changing the fuse
) .
The camera does not
record properly during
the journey .
There is a
problem with the
built-in motion
sensor .
Activate the built-in motion sensor
(function "Motion detection" in the setup
menu) only while the vehicle is parked .
Increase the sensitivity of the motion
sensor .
Summary of Contents for CR 5 A2
Page 3: ...a e b C d...
