Head support adjustment:
➭
Lift the head support with one hand and at the
same time, with the other hand on the lever
for the head support adjuster, move the head
support into the desired position.
Tool storage:
➭
You can open the footrest
if you wish to use
the space below it for temporary tool storage.
Cleaning
➭
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the appliance. Do not use solvents
or abrasive cleaners on the plastic surfaces, they
could be damaged by them.
Disposal
Do not dispose of the appliance in your normal
domestic waste.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
- 4 -
Device overview
Items supplied:
1 x Workshop Creeper
7 x Wheels, each with 1 sleeve nut
1 x Operating instruction
Appliance:
Footrest, Tool storage
Sleeve nut
Lever for head support adjustment
Strap
Lever for safety closure
Castor with screw bolt
Recline position
Seated position
Utilisation
Assembly:
➭
Insert the screw bolt
of the castor to be as-
sembled through the steel frame from below.
➭
Insert a sleeve nut
from above through the
steel frame and tighten it down with an Allen
key (SW 5 mm).
➭
Repeat this procedure for each castor.
Position adjustment:
➭
Grasp the strap
with the right hand.
➭
With the left hand keep the lever of the safety
closure
pressed down ...
➭
and at the same time pull on the right-sided part
of the appliance up into the seated position
or push it down into the reclining position
.
➭
Now allow the lever of the safety closure
to reengage.
IB_KH4135_U567_LB4 07.09.2007 14:06 Uhr Seite 4
