KT-70E / KT-90E / KT-70SE User Manual
Page 29 of 59
24 April 2018
7.
Start-up
To avoid damage or serious injury during startup of the compressor, the following points
must be observed:
-
The commissioning of the compressor may only be carried out by qualified staff in
compliance with the safety.
-
Check before the first start that all tools and foreign objects were removed from the
compressor.
-
Check before commissioning the motor rotation direction.
-
Also read the chapter "General safety instructions".
7.1.
Power
Electrical connection
.
Observe the following for the electrical connections;
-
Comply with local electrical codes.
-
Installation of electrical receptacles should be performed by licensed electricians.
Gasoline Engine
Note: Supplier for Gasoline Engine may vary.
7.2.
Checks before initial Start-up
F
Remove all packing used in transport
F
Check that all screws and bolts are secure
F
Check all cables and connectors.
F
Check the oil level
The oil level should be at the middle mark on the dipstick, or higher.
F
Check filter system for damage and completeness. Insert the filter car-
tridge.
All protective devices must be correctly fitted.
i
Summary of Contents for KT-70E
Page 49: ...KT 70E KT 90E KT 70SE User Manual Page 49 of 59 24 April 2018 Figure F First Stage Cylinder...
Page 51: ...KT 70E KT 90E KT 70SE User Manual Page 51 of 59 24 April 2018 Figure 8 Third Stage Cylinder...
Page 53: ...KT 70E KT 90E KT 70SE User Manual Page 53 of 59 24 April 2018 Figure 10 Filter Housing...
Page 54: ...KT 70E KT 90E KT 70SE User Manual Page 54 of 59 24 April 2018 Figure K Casing...
